How To Install Retrofit Projectors

Install Retrofit Projector Headlights on a Suzuki

This commodity is visible to but y'all.

Installing LED Bi-Xenon Projector Retrofits is a smashing afternoon project that is a nice motorcar upgrade from dim stock manufacturing plant light to a gorgeous crisp white glow. This guide covers everything from undoing the bumper in the offset all the fashion to mounting the shrouds.

• flathead screwdriver

1

Disengage the bumper mounting screwed by slipping a flathead screwdriver into the plastic clip in the bike well and button it directly in. The center volition pop up so yous tin can remove the clip. There is a Phillips screw at the indent in the bumper cover that needs to be removed.

2

Use the Phillips to remove the top bumper screwed along the rad support. Yank the sides of the bumper to pull information technology free from the fender. There are two rubber hood stoppers that you have to pull the bumper over. For the headlight, remove the screw nether the bumper corner, two at the top, and use a flathead screwdriver to pop the clip connected to the fender.

iii

Remove the plugs that go into the light and pull out the clip it'southward connected to at the bottom inside corner. Heat the perimeter of the lens using a heat gun or an oven and gently pry the headlight open. Make sure the tabs are out of the way to the lens can release.

4

Afterward the headlight is open up, remove the bulb shield from the reflector by pulling off the safe dust kicking at the back of the low-cal first. There are ii tabs bent over that hold the shield in. All you need to do is bend them dorsum straight and pull the shield out of the reflector.

5

Time to mount the projectors! There is a bulb holder that is held on with 3 screws that yous'll need to remove from the dorsum. The large silicone rings that need to go to the dorsum of the projector. Slip the projector through the bulb pigsty. You volition need to fasten it with the threaded ring and washer.

vi

This is only if your kit has the plug installed on the bi-xenon solenoid'southward wires: Utilise a paperclip to press the pocket-sized tabs on the pins and pull out the plug. There volition exist a hole from the old seedling where you will feed the wires.

7

Put the prophylactic dust boot into the back of the light and allow the solenoid wires to come through the center of the boot. Put the bulb holders dorsum and clip the H1 HID capsules into the projectors. Twist the projector to get the 2 projector cutoffs level with each other. Turn them off and you can mountain the shrouds and put the lenses back on after.

eight

Installation will be different for every shroud y'all choose, merely the general idea is pretty much the aforementioned. For the about part, the shroud is a press fit onto the projector. Use a heat gun to warm the mucilage to press the housing together. The tabs should take hold of on and after this you lot can mount the relay and ballasts.

Y'all're at present done and can bask your new lights. Credit goes to WylieC from Clubsx4.

Get notified about new articles.

We'll keep you lot upward to date about the newest motorcar tips and tricks.

Nosotros don't sell or share your info.

Source: https://howtune.com/articles/176-install-retrofit-projector-headlights-on-a-suzuki

Posted by: wardnearst.blogspot.com

Share this post